支持与服务: 概述; 客户培训; 技术支持; 咨询项目; 汽车电子

Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

How to bind qnet to a specific network interface

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: How to bind qnet to a specific network interface
SDP: 6.5.0
Target: Any supported target

________________________________________________________________________

Issue

________________________________________________________________________

We are trying to bind qnet to a specific network interface, e.g. en1 using the bind= qnet option and it doesn't appear to be working.

________________________________________________________________________

Recommendation

________________________________________________________________________

bind= is used to bind the qnet communication either IP or Ethernet protocol, not for binding to a specific interface. This needs to be done by altering the routing table, e.g. route add .....

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.